Step 3: Installing a Demo License

Before you can use TotalView, you must place the demo license into the flexlm-version directory. This license file, which is called license.demo, was attached to the email message confirming your download request. If your email system didn't retain this name, you must rename it after you save it to disk.

  1. If you installed TotalView as the root user, become the root user again. If you used sudo to install TotalView, use sudo in the following step.
  2. Copy the license file to the flexlm-version directory.

    3. cp license.demo installdir/toolworks/flexlm-version

  3. To test that TotalView can use the license file, type:

    4. installdir/toolworks/totalview.version/bin/totalview

    TotalView responds by displaying its Root window.

Note
After you purchase TotalView, you will receive a permanent license. For more information, refer to the TotalView Installation Guide. You will find this guide within the TotalView help or on our web site at http://www.totalviewtech.com/Documentation.

 

TotalView Technologies.
http://www.totalviewtech.com
Voice: (508) 652-7700 		version 8.7
Copyright © 2009, TotalView Technologies, LLC. All Rights Reserved.
Comments to: documentation@totalviewtechnologies.com